ProCurve 6400cl Uživatelská příručka stáhnout pdf (Strana 403)

100

101

Access Control Lists (ACLs) for the Series 5300xl Switches

Configuring and Assigning an ACL

Syntax: [no] access-list

Creates an ACE in the specified (100-199) access list and:

• Indicates the action (deny or permit) to take on a packet

if there is a match between the packet and the criteria in

the complete ACE.

• Specifies the packet protocol type (IP, TCP, or UDP).

• Specifies the source and destination addressing options

described in the remainder of this section.

• Allows optional ACL logging where a packet has a match

with a deny ACE.

If the ACL does not already exist, this command creates the

specified ACL and its first ACE. If the ACL already exists,

this command adds a new, explicit ACE to the end of the

ACL. For a match to occur, the packet must have the source

and destination IP addressing criteria specified by this

command, as well as any protocol-specific (TCP or UDP

port number) criteria specified by the command. To create

a named ACL, refer to “Configuring a Named ACL” on page

9-44.

< 100-199 >

Specifies the ACL ID number. The switch interprets an ACL

with a value in this range as an extended ACL.

Note: To create an access list with an alphanumeric name

instead of a number, refer to “Configuring a Named ACL”

on page 9-44.

< deny | permit >

Specifies whether to deny (drop) or permit (forward) a packet that

matches the ACE criteria.

< ip | tcp | udp >

Specifies the packet protocol type required for a match:

• ip — any IP packet

• tcp — only tcp packets

• udp — only udp packets

9-39

1 2 ... 398 399 400 401 402 403 404 405 406 407 408 ... 717 718

Komentáře k této Příručce

Žádné komentáře

ProCurve 6400cl Uživatelská příručka Strana 403

Komentáře k této Příručce

Související produkty a manuály pro Síťové přepínače ProCurve 6400cl