IP Routing Features
Configuring OSPF
default settings (disabled or configured for either two or three equal-cost next-
hop paths), then the current settings are displayed in the command output.
ProCurve(config)# show running
Running configuration:
; J9091A Configuration Editor; Created on release
#K.12.XX
hostname "ProCurve"
module 1 type J8702A
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged A1-A24
ip address dhcp-bootp
exit
ip load-sharing 3
access-controller vlan-base 2000
Indicates a non-default IP load-sharing configuration
allowing three equal-cost next-hop paths for routed traffic
with different subnet destinations. If the routing switch is
configured with the default IP load-sharing configuration, IP
load-sharing does not appear in the show config or show
running command output.
Figure 5-42. Displaying a Non-Default IP Load-Sharing Configuration
5-111
Komentáře k této Příručce